MIB System
System Name
This section is to give a name to a NetAgent.
System Contact
This section is to give a name to the administrator.
System Location
This section is to set NetAgent location.

	Access Control
Manager IP Address
This section is to set the IP address that the administrator can manage NetAgent from. It is valid for up to 8 IP addresses. To manage NetAgent from any IP address, enter *.*.*.* into "Manager IP address".
Version
This section is to set SNMP versions.
Community
This section is to set a Community name for NMS. The community name has to be as the same as the setting in NMS.
Permission
This section is to set authorities of administrators. Options are Read, Read/Write, and No Access.
User Name
This section is to set SNMP user's account. (Only if use SNMPv3)
Password
This section is to set SNMP user's password (Only if uses SNMPv3)
Authentication
This section is to select between MD5 or SHA (Only if use SNMPv3)
Privacy
This section is to select between DES or AES (Only if uses SNMPv3)
Description
This section is for an administrator to make notes.

	Trap Notification
Receiver IP Address
This section is to set receivers IP address for receiving traps sent by NetAgent. It is valid for up to 8 IP Addresses.
Community
This section is to set a Community name for NMS. The community name has to be as the same as the setting in NMS.
Trap Type
To select between PPC or RFC1628.
Severity
This section is to set Trap receiver levels. There are three levels of Trap receiver : Information: To receive all traps. Warning: To receive only “warning” and “severe” traps. Severe: To receive only “severe” traps. (Please refer to NMS manual for Trap levels.)
Accept
This section is to set to receive a trop or not.
Description
This section is for an administrator to make notes.
Event
This section is to select events for NetAgent to send traps. Clicking on Select will open a Select Events List. Event Traps may be selected from this list. Events list is below:

	Device Connected
This section is to set the usage power and connection status of other devices which connects to the same UPS as NetAgent uses.

	SNMP UDP Port
This section is to set the SNMP and Trap port. (SNMP default is USD161 ; Trap default port is UDP162)

This page is to set NetAgent SNMP settings so it can be used by a NMS ( Network Management System). (Eg: SNMPView, SNMPView can be found on the NetAgent Utility CD.)