NetAgent A
NetAgentA
Information
Configuration
Log Information
Management
  • Remote Control
* This page is to provide remote UPS test functions. Choose the test item, then click on 'Apply' to execute it. (Please refer to the UPS manual for individual UPS Test functions.)
If you are using a Contact Closure UPS, you will only be able to use the function ' Turn off UPS when AC Failed'.
UPS Testing
Deep Battery Test for _ minute(s) This is to test if battery works normally.
Test until battery capacity below _ % This function is to execute until battery capacity below set-point.
Test Until Battery Low This function is to execute until battery low.
Cancel Test This function is to abort a test when it is executing.
Miscellaneous
Turn off UPS when AC failed/Reboot UPS Selecting 'Turn off UPS when AC failed' will turn off the UPS. You can reboot the UPS by selecting 'Reboot UPS'.
Put UPS in Sleep mode for __ minutes/Wake up UPS When the UPS is put into Sleep mode, it will not provide power. The UPS will provide power again after Sleep mode time is complete.
Reboot UPS When execute such command, UPS load would start over.
Wake Up UPS This function is to start up the UPS.
UPS Buzzer On/Off This is to turn on/ off the UPS buzzer.