NetAgent A
NetAgentA
: NetAgent Cloud Online
: NetAgent Cloud Offline : Go to NetAgent Cloud Settings
: Current user : Log Off
Information
Configuration
Log Information
AI Analysis
Management
SNMPView Lite
  • UPS Properties
  • Test Log
  • Warning Threshold Value
* This page is to set the UPS configuration. Any wrong settings will cause incorrect display values or disconnection between the UPS and NetAgent.
 
UPS Communication Type This section is to set up the communication interface of the UPS. (eg. Contact Closure/RS232/3 phase etc.) Please refer to the UPS manual to set the correct communication type. Any wrong settings will cause disconnection between the UPS and NetAgent.
Number of Batteries,
Battery Full Charge Voltage (V),
Battery Exhausted Charge Voltage (V)		 Please refer to the UPS manual to set the value.
Date of last battery replacement (yyyy/mm/dd) This section is to record the date when the UPS battery was last replaced.
 
Test UPS
Test UPS for every This section is to schedule the UPS to test once a week, month, quarter, once every 2 weeks or 4 weeks or not to test.
Test UPS on Day This section is to set the UPS to test on a particular day of a month or quarter.
Test UPS on Weekday This section is to set the UPS to test on a particular day of a week.
Start Time of UPS Testing (hh:mm) This section is to set the UPS to test at a certain time on the test day.
UPS Test Type This section is to select the type of self test to perform.
UPS Recorder
UPS Data Log This section is to set how often the UPS data should be logged. (You can set to disable data logging here.)
 
 
Time out of after lost of connection This section is to set a period of time after which NetAgent will send a disconnection warning message. This warning message will be sent after NetAgent has lost contact with the UPS for the time specified.
Critical Loading (%) This section is to set the UPS critical loading. (shown as %) NetAgent will send a warning message when the UPS is overloaded.
Critical Temperature This section is to set the UPS critical internal temperature. NetAgent will send warning messages when the UPS overheats.
Units are optional °C or °F
Critical Capacity (%) This section is to set the UPS critical battery capacity (shown as %) NetAgent will send warning messages when UPS low battery occurs.