NetAgent A
NetAgentA
Information
Configuración
Bitácora
Management
  • Remote Control
* This page is to provide remote UPS test functions. Choose the test item, then click on 'Apply' to execute it. (Please refer to the UPS manual for individual UPS Test functions.)
If you are using a Contact Closure UPS, you will only be able to use the function ' Turn off UPS when AC Failed'.
Prueba de SEI
Prueba de descarga profunda de Batería por _ minuto(s) This is to test if battery works normally.
Chequear hasta que la capacidad de baterias sea menor que _ % This function is to execute until battery capacity below set-point.
Prueba de descarga hasta Batería Baja This function is to execute until battery low.
Cancelar Prueba This function is to abort a test when it is executing.
Varios
Apagar el SAI cuando falle la línea comercial/Reiniciar SAI Selecting 'Turn off UPS when AC failed' will turn off the UPS. You can reboot the UPS by selecting 'Reboot UPS'.
Mandar el SAI a dormir por __ minuto(s)/Despertar SAI When the UPS is put into Sleep mode, it will not provide power. The UPS will provide power again after Sleep mode time is complete.
Reiniciar SAI When execute such command, UPS load would start over.
Despertar SAI This function is to start up the UPS.
Enc/Apag de la alarma audible del SAI This is to turn on/ off the UPS buzzer.