원격제어_NetAgent Help

원격제어

* This page provides remote UPS testing capabilities. Select a test item, then click 'Apply' to execute the command. (Please refer to the UPS manual for details on specific test functions.)
If you are using a Contact Closure UPS, only the 'Turn off UPS when AC Failed' function is available.

UPS 테스트

10초 테스트	This is a 10-second battery test.
분동안 딥밧데리테스트를 하다 _	This is to test if battery works normally.
배터리 용량 _ % 이하까지 테스트 하십시오	This function is to execute until battery capacity below set-point.
배터리부족시까지 테스트	This function is to execute until battery low.
테스트취소	This function is to abort a test when it is executing.

기타

정전시 UPS 끄기/UPS 재부팅	Selecting 'Turn off UPS when AC failed' will turn off the UPS. You can reboot the UPS by selecting 'Reboot UPS'.
__ 분 동안 UPS를 슬립모드에 두세요/UPS를 정상모드로 전환	When the UPS is put into Sleep mode, it will not provide power. The UPS will provide power again after Sleep mode time is complete.
UPS 재부팅	When execute such command, UPS load would start over.
UPS를 정상모드로 전환	This function is to start up the UPS.
ups 경고음 On/Off	This is to turn on/ off the UPS buzzer.