UPS On/Off 스케쥴_NetAgent Help

UPS Action
Remote Shutdown
주간스케쥴
일일스케쥴
랜 작동

When UPS event (UPS 과부하 / 정전 발생 / UPS 배터리 저전압 / UPS 과온도 / 배터리 부족) or NetFeeler event (과온도 / 저온도 / 과습도 / 저습도 / 습기 / 연기 / 가스 / 보안1~7) occur, then delay turn off UPS or Host (setting on "Remote Shutdown" tab)

This section is to set 8 host for remote shutdown. Shutdown action can be executed by setting action on "UPS Action" tab or clicking on Test button.
Please test before using this function.

* Please remember to click "Apply" to save your changes.

This section is to set the time to turn on/off the UPS each day in the week. Click a time point to configure the time and power status. Clicking it again allows you to edit or remove the setting. : UPS turn-off time. : UPS turn-on time. : UPS on during this time.
스케쥴셧다운이벤트전에 _ 경고가 뜰것입니다	NetAgent will send a warning message before a scheduled shutdown. This section sets the delay time period after the message is sent and before the scheduled shutdown is started.

* Please remember to click "Apply" to save your changes.

This section is to set the time to turn on/off the UPS on particular days. (Eg, holidays.) After setting the time and action on the right, the calendar view on the left will visually display the UPS power status. : UPS turn-off time. : UPS turn-on time. : UPS on during this time.
스케쥴셧다운이벤트전에 _ 경고가 뜰것입니다	NetAgent will send a warning message before a scheduled shutdown. This section sets the delay time period after the message is sent and before the scheduled shutdown is started.

This section is to wake the PC within the network. (Make sure the PC has such function supported and configure as "Enabled" under BIOS.) Enter the IP address of that PC and system would search its MAC accordingly. You can test this feature before using it.
전원 복구후 원격 호스트를 웨이크업 하십시오 배터리 용량이 _ % 될 때까지 기다리십시오.	This section is set to wake up the remote host when the utility power is restored or the battery capacity reaches the preset value.
Wake up remote host after UPS output restore 배터리 용량이 _ % 될 때까지 기다리십시오	This section is set to wake up the remote host when UPS output is restored or the battery capacity reaches the preset value.