UPS 설정_NetAgent Help

* This page is to set the UPS configuration. Any wrong settings will cause incorrect display values or disconnection between the UPS and NetAgent.

UPS 통신형태	This section is to set up the communication interface of the UPS. (eg. Contact Closure/RS232/3 phase etc.) Please refer to the UPS manual to set the correct communication type. Any wrong settings will cause disconnection between the UPS and NetAgent.
배터리수량, 밧데리 최고충전 전압 (V), 밧데리 방전 전압 (V)	Please refer to the UPS manual to set the value.
최종배터리교체일 (mm/dd/yyyy)	This section is to record the date when the UPS battery was last replaced.

UPS 테스트

UPS 테스트간격	This section is to schedule the UPS to test once a week, month, quarter, once every 2 weeks or 4 weeks or not to test.
UPS 시험 날자	This section is to set the UPS to test on a particular day of a month or quarter.
주중 UPS 테스트	This section is to set the UPS to test on a particular day of a week.
UPS 테스트시간(시:분)	This section is to set the UPS to test at a certain time on the test day.
UPS 테스트 형식	This section is to select the type of self test to perform.

UPS 기록

UPS 데이터로그

This section is to set how often the UPS data should be logged. (You can set to disable data logging here.)

연결끊김에 대한 타임아웃	This section is to set a period of time after which NetAgent will send a disconnection warning message. This warning message will be sent after NetAgent has lost contact with the UPS for the time specified.
한계 부하 (%)	This section is to set the UPS critical loading. (shown as %) NetAgent will send a warning message when the UPS is overloaded.
한계 온도	This section is to set the UPS critical internal temperature. NetAgent will send warning messages when the UPS overheats. Units are optional °C or °F
한계 용량 (%)	This section is to set the UPS critical battery capacity (shown as % )NetAgent will send warning messages when UPS low battery occurs.